←
The Difference Between a Heat Shrink Gun and a Torch
One of the best things you can do for your boat when you put it into storage for the winter is to cover it in shrink wrap. But it is important to know how to wrap it correctly. Discover several important tips on how to heat shrink wrap a boat for winter so that you can protect it more effectively.
Before you start the wrapping process, it is important to cover certain hazards on your boat. Put tape over your boat’s fuel vent to ensure no fumes escape when using your heat gun to tighten the wrap.
When finished with the wrapping process, you can remove the tape. You should put foam or tape over any sharp areas on the boat, as well.
Asking someone to help you is another good tip for shrink wrapping a boat. The process can be very complicated, so getting a friend’s assistance will make it easier for you to finish.
When you use your heat gun to shrink your wrap, try to use it in a side-to-side motion. Otherwise, if you center it on one area, you will risk damaging the wrap and must fix it. Additionally, it is a good idea to have a fire extinguisher on hand during this process in case you accidentally start a fire.
If you are unable to dry your boat properly before you apply the heat shrink wrap, you can prevent mold or mildew by installing vents on the wrap. The vents will allow the moisture to escape, helping you mitigate the risk of unwanted mold growth.
When you finish wrapping your boat, give it one last look to see if you can spot any holes in the shrink wrap. If there are small holes, you should be able to fix them by bonding shrink wrap tape to the larger wrap with the help of your heat gun.
Knowing these tips on how to heat shrink wrap a boat for winter will allow you to get the most boat protection. Contact us to buy shrink wrap for packaging, heat shrinking tape, and the shrink wrap heat guns you need to keep your boat safe during the cold winter.
